Clogs are common in almost every household and place of business. Even if you take special care not to put anything that might cause a clog down the drain, there is a good chance that excess bits of food, grease, hair, or other unsavoury materials and pieces will eventually line and clog your pipes. So, what should you do when a clog takes over your kitchen sink? Here are a few simple steps for quick removal.
- Disconnect Your Garbage Disposal – Before you do anything, you will need to disconnect the disposal from the sink so you have access to the drain. Start by unplugging your disposal – never work on your sink or the garbage disposal with it plugged in. If the disposal itself is clogged, turn the blades manually to work free any clogs. If it turns freely, the clog might be past the disposal in the pipes and it will need to be removed for further cleaning. Most of the time, however, the clog will be either in the disposal or in the opposite sink.
- Plunging Your Sink – Once you have ruled out the disposal, it is time to plunge the sink. Make sure to clamp off the line from your dishwasher so that you do not push any water back into the machine. If you have two sink drains, make sure to seal up the one you are not plunging so that a good seal is created. Do NOT plunge the sink if you have poured any chemicals down in an attempt to clear the drains.
- Cleaning Out the Trap – If a plunger cannot get the job done, it is time to check the P-trap. To do this, remove as much water as possible from the sink and place a bucket under the trap so you do not make too big of a mess. Now, disconnect the p-trap from the trap arm. If you have an older metal sink assembly, you may need a wrench or pliers to get the Slip Nuts free. Plastic is much easier. Check the trap to see if there is a clog in the curve of the joint. If not, you will need to move on to the final possible fix.
- Snaking – If you cannot clear the clog with a plunger and your hands, it may be time for a snake. You can rent one from most hardware stores if you do not own one, and it is a lot cheaper than calling a plumber to do it for you. You will need to remove the trap arm from the drain itself and then run the snake down the line until you find the clog. This can be a time consuming process, but most often it will take care of any remaining clogs.
Pompeii’s Custom Plumbing is Now a Part of Westland HVAC + Plumbing.
Same great service with more to offer. Call our team of experts for prompt, friendly, and professional services if you need anything else.
